0 item(s) - AU$0.00
You have no items in your shopping cart.


Gasket, Seal, Bush & Bearing

13 Item(s)

List  Grid 

  1. speed front input bearing 111.65978 IMG_8909.jpg

    4 Speed Front "Input" Bearing

    High Quality Replacement Bearing suit 4 Speed Learn More
  2. large_5248_4-spd-plug.jpg

    4 Speed Shifter/Honeypot Housing End Plug

    Suitable for use in all Borg Warner 4 speed single-rain transmissions. Learn More
  3. Clutch Pilot Spigot Bush

    Clutch Pilot Spigot Bush

    Sintered bronze replacement input shaft spigot (clutch pilot) bush to suit chrysler, valiant, dodge & plymouth original equipment manual transmissions. Learn More
  4. rear extension housing seal 3 speed manual with trunion.jpg

    Extension Housing Output Seal , Suit Early 3 Speed Torqueflite w/ Ball and Trunion

    Extension housing output shaft seal : ball & trunion Extension housing seal to suit original equipment RV1, SV1, AP5, AP6 & VC manual transmission and RV1, SV1 & AP5 automatic... Learn More
  5. FELPF_TS133815_P04_TOP.jpg
  6. front carrier gasket seal suit 4 speed manual transmission IMG_8530.jpg

    Front Carrier Gasket Seal : suit 4 Speed Borg Warner Manual Transmission (nose cone seal)

    Nose Cone seal suit Borg Warner 4 speed transmissions. Learn More
  7. OLD 4 speed gaskt kit.jpg

    Gasket Set, Manuel, BorgWarner 4 Speed ( Excl seals)

    These hi-quality transmission gaskets will keep the good in and the bad out. Keep your transmission running at its best by replacing these common gaskets. Set Includes: Lid Gasket Extension... Learn More
  8. large_1683_ndle.jpg

    Needle Roller Bearing Kit (108x) : suit Borg Warner 4-speed Manual (early)

    If you're rebuilding your Borg Warner 4-speed manual transmission, be sure to check the part number of your gearbox! These hard to find needle roller bearings are fitted to all... Learn More
  9. 4 speed lid gasket.jpg

    Nitrile Transmission Top Cover Gasket : 4-speed Manual

    Nitrile transmission top cover gasket : 4-speed manual Nitrile engine gaskets are guaranteed to provide premium performance & sealing qualities. Manufactured with greater oil & chemical resistance than typical cork... Learn More
  10. large_4041_308-bearing.jpg

    Output Shaft Bearing : suit A-833 4-speed manual (26-spline)

    High quality output shaft bearing to suit new process A-833 4-speed manual transmission. Suits A-833 four-speed transmission (with 26-spline output shaft) Hi-quality bearing Learn More
  11. New 4 Speed Rear extension housing Bush Enlarged IMG_3267 Small.jpg

    Rear Extension Housing Bush : suit Borg Warner 4 Speed Manual & Torqueflite 727 3 Speed Auto

    Suit Borg Warner 4 Speed Manual and Torqueflite 727 3 Speed Auto transmissions found in Chrysler Valiant motor vehicles. Learn More
  12. large_3627_a833-rear-seal.jpg

    Transmission Rear Extension Housing Seal : suit A833 (new process 4-speed)

    Direct replacement shrouded extension housing seal (output shaft seal) two-stage oil seal suitable for use on all new process A833 manual transmissions. Direct replacement seal Suits A833 manual transmission (26-spline) Learn More
  13. Transmission Rear Output Seal and Bush set, Suit Borg Warner 4 Speed & 727 TorqueFlite (Transmission to Yoke seal)

    Transmission Rear Output Seal and Bush set, Suit Borg Warner 4 Speed & 727 TorqueFlite (Transmission to Yoke seal)

    Suit Borg Warner 4 Speed Manual and Torqueflite 727 3 Speed Auto. Seal Specifications Shaft: 1.688" O.D.: 2.850" Width: 2.120 Includes dust seal: Yes Learn More

13 Item(s)

List  Grid 

© Hemi Performance. All Rights Reserved.